DAELEN
Posts : 50 Reputation : 9 Join date : 2009-08-26 Location : It's 11PM, do you know where your pants are?
| Subject: HOW TO MAKE AN- LINES Fri 28 Aug 2009, 04:50 | |
| So here is how I make the lines...
I got four -8AN hose ends, two 1/2” pipe to -8AN adapters, 3’ of -8AN braided stainless hose First I cut the 3 feet of stainless hose in half by taping it with electrical tape and cutting it with the cutoff wheel.
Then I stripped off the electrical tape and slid the hose into the red part of the hose end, putting the end of the hose flush with the threads.
Then I lubricated the blue part of the hose end with some white lithium grease.
Next I clamped the red part into the vice using an AN assembly clamp and pushed the blue part of the AN fitting into the red.
I twisted it with my palm until the threads engaged then used a 7/8” AN wrench to tighten them.
I tightened the fitting until the red and blue parts were just about 1mm apart.
and viola you're done. I would advise however to blow some high pressure air thru the lines to get out any crap from cutting them. Also it hides the coolness but shrink wrapping the lines prevents them from fraying. | |
|